An Alternative to Assembling Components in the Field. Power Panels are Trace’s first packaged power system. They are less expensive than an on-site component installation and meet many power application needs. To install a Power Panel, simply connect them to the battery, PV and or AC loads. Power Panels include inverters and are assembled by Trace with components specified at the time they’re ordered to paneles solares
Included in all Power Panel Systems:
Powder-coated steel backplate prewired with all NEC / UL required AC & DC overcurrent protection and disconnects (only for indoor installation). Simply connect to the battery and AC loads and your system is operational.
Can be used with wind, solar, or hydro DC charging sources
60 amp AC system bypass that allows inverter servicing while keeping AC loads connected to the grid or generator
Flexible conduit for connection of the system to the battery enclosure
ETL listed components and enclosure
Negative/ground bonding block
SW Series Power Panels
Sine wave AC power inverter with high-efficiency, bidirectional operation
Up to 11 kW of continuous AC power
Up to 60 amps of AC input from a generator or utility grid
Three-stage, temperature-compensated battery charging
(up to 300A @ 12VDC, 240A @ 24 VDC, and 150A @ 48 VDC)
Utility-interactive and generator-support operating modes
Able to regulate up to 4.8 kW of power from solar or other DC charging sources
Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz.
Available for a 12, 24 or 48-volt DC system
DR Series Power Panels
Modified sine wave AC power inverter with high-efficiency operation and battery charging ability
Up to 7.2 kW of continuous AC power (120/240 vac systems)
30 amps of AC pass through power at 120 or 120/240 vac from a generator or utility grid to your loads, in addition to the charger draw
Three-stage, temperature-compensated battery charging – up to 240A @ 12 VDC or 140A @ 24 VDC
Able to regulate up to 2.4 kW of power from solar or other DC charging sources
Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz
Available for 12 or 24-volt DC system
SW and DR Options
Optional nonmetallic battery enclosure which doubles as a shipping enclosure
Single or dual C40 Charge controllers for solar, wind, hydro DC charging sources
One or two Trace SW or DR inverters
Note: Products are listed by UL and/or ETL to UL specifications.